Intensifier Pump

Various models waterjet Cantilever/Bridge/Lifter 3axis/4axis/5axis High cost performance/fast delivery time CE certificate

The intensifier acts as an amplifier as it converts the energy from the low pressure hydraulic fluid into ultra-high pressure water. The hydraulic system provides fluid power to a reciprocating piston in the intensifier center section. A limit switch, located at each end of the piston travel, signals the electronic controls to shift the directional control valve and reverse the piston direction.

The intensifier assembly, with a plunger on each side of the piston, generates pressure in both directions. As one side of the intensifier is in the inlet stroke, the opposite side is generating ultra-high pressure output. During the plunger inlet stroke, filtered water enters the high pressure cylinder through the check valve assembly. After the plunger reverses direction, the water is compressed and exits as ultra-high pressure water and then enters the pressure vessel(accumulator) The accumulator smoothes pressure fluctuations from the intensifier and delivers a constant and steady stream of ultra-high pressure water to the cutting tool.

Technical data of the pump:

1.Type of pressurization is hydraulic. (The water is pressurized by using the fluid pressure intensification principle) 

2.Max. oil discharge is 90 L/min 

3.Max. water discharge is 3.0L/min                                    

4.Max. diameter of orifice is 0.26mm

5.Max. operating pressure is 300MPa

6.Continuous operating pressure is 260MPa        

7.Power requirement : 18.5KW,380V/50HZ

8.Type of shift is electronic

 

 

Intensifier Pump